Post by demandypants on Sept 26, 2014 6:42:23 GMT -5
I stared at this way to long. Cause not only did it bother my OCD but also i NEEDED to understand why it was wrong. That bottom left side of the hex is too narrow (3, not 4 wide) moving the black boarder up to match the little bit jutting out and then another row of brown will fix it.
If the only thing wrong was the four rows vs three rows thing it would be pita to fix, but still fixable. To me, the biggest problem is that the entire thing is uneven. The top left side is longer than the top right side, (which screws up the lengths on the sides), but the lower sides are done right as far as centered correctly.
If the only thing wrong was the four rows vs three rows thing it would be pita to fix, but still fixable. To me, the biggest problem is that the entire thing is uneven. The top left side is longer than the top right side, (which screws up the lengths on the sides), but the lower sides are done right as far as centered correctly.
Yes, I had this problem with it too but you worded it much better than I could have